Laser Interceptor Generation 8 Laser Interceptor - QUAD

Description

Laser Interceptor QUAD Head Laser Jammer 

Laser Interceptor is an active Laser Jammer, which means it sends out beams blocking police lasers, as opposed to radar detectors that will only warn you your speed has been measured. Laser Interceptor is a LIDAR triggered Laser Jammer that transmits a Jamming Beam only upon detection of a LIDAR signal and does so for the duration of that signal and then immediately disengages when that signal is no longer detected. Laser Interceptor will then immediately reengage again upon the detection of another LIDAR Signal(s). The Laser Interceptor Laser Jammer consists of two units. Each unit consists of a receiver and a transmitter. Both are installed on the front of the vehicle. Additional sensors can be purchased to protect the rear of the vehicle as well. Every time the device is turned on, it performs a self test after which welcome sound is played. The transceiver unit has two built-in sensors that are sensitive to laser beams. When the sensor receives a laser beam, it forwards the impulse to a high speed microprocessor, which then analyzes it and sends corresponding impulses to transmitter LASER.

Radiation emitted by LASER diodes cannot harm your eyesight, it is class 1M by EC60825-1. Both units are synchronized, which increases the jamming effect. When a lidar device receives the impulses from a vehicle with a built-in Laser Interceptor, it will not be able to measure the speed, because it will get the wrong information about the current distance from the vehicle and therefore will not show the speed. Every time an attempt is made to measure your speed, the device will warn you with an audio warning sound and a Voice Alert as to the type of LIDAR being used. Also, the device will warn you when the sensor is blinded by the sun, since the sun is a strong source of all wave lengths, including the one lasers work on. This can happen when you are driving toward the sun or when the sun is close to the horizon. The device has a built-in thermo regulation so as to work optimally in extreme temperature conditions. The housing is made from black plasticized aluminum, with an optical lens on the front, and is resistant to mechanical damage.

The weatherproof Aluminum Enclosures holds a delicate circuitry for infrared laser light detection, and a high power, infrared Laser Diode. The incoming infrared light is focused by Optical Culmunator on the the detection diodes, and then amplified and processed. The Laser Diode emits similar pulses to those transmitted by LIDAR. As our design uses a real Laser Diode, exactly the same device used by police LIDAR Guns, instead of the cheap, infrared LEDs found in TV remote controls, it is much more powerful, effective and reliable.

LI QUAD Components:

• CPU box with built in 90 db Speaker for Audio Alerts, RS-232 Connector for User Changes via the LI User's Software
• OPTIONAL PA/JAM Selection Switch (NOT INCLUDED) (Allows the User to instantly switch the LI from JAM to PA MODE)
• Power switch with built in LED Indicator for ON/OFF and Flashes upon LIDAR Detection and Jamming
• CPU unit power connector with provisions for MUTE as well as an External, User Provided Speaker
• Installation accessories, Stainless mounting hardware, 4 L-Type and 4 Aluminum brackets (2 Front Optional), bubble-level for sensor installation and zip-ties

The Most Protection At Any Price

There are a lot of LIDAR Countermeasures (Laser Jammers) on the market. Some are the same price as ours, some cheaper and some more expensive. None of them offers the level of protection of the Laser Interceptor for the price. You can't beat it!

Dual Receivers

Usually, two is better than one. In the case of laser pulse detection, obviously this is the case as well. The better the detection, the better the Jamming!

Precision

We don't take anything for granted. Our hardware and software is super accurate, down to 0.000000001 pps!! That's better than most LIDAR units!

Fast, 128 Bit - 200 Mhz RISC High Speed Processor

Speed and accuracy ensures quick processing times with precise timing necessary to defend against the latest LIDAR threats.

Powerful Laser Diodes

More power is usually better. Unlike most other Laser Countermeasures, we use a powerful OSRAM SPL90-3 Pulsed Laser Diode (the same device used in actual Police LIDAR Guns) to ensure maximum effectiveness.

No "JAM" Codes

Unlike the competition, when actively jamming a LIDAR unit, there is no "JAM" codes on the laser gun display. The LIDAR operator has no idea they are being  jammed.

Parking Aid Mode

Would you like to have a simple parking aid which beeps when a solid object is in front of the unit? Maybe you only want to  use the LI as a parking unit? This feature is built in.

Easy Installation

There is only one cable leading each sensor to the CPU. Once each sensor is properly installed and leveled, connections to the CPU mounted inside the Cockpit are made easy with simple, snap-in RJ12 Connectors and a single Molex type Connector for the CPU's 12V and other ancillary functions. Mounting the LED equipped switch completes the installation.

New LIDAR? LI Is Firmware Upgradeable!

All our units are Firmware upgradeable and are never obsolete and the Newest Generation 8 Laser Interceptor now features FREE User Downloadable Updates! When new LIDAR threats are deployed by Law Enforcement, newly released firmware can be downloaded in to the device to address and defeat these and any future LIDAR threats.

LI-USA Exclusive 2 Year Transferrable Warranty

We provide a Two Year Warranty on Components and Workmanship.